FEETECH FE-URT-2 – USB to TTL/RS485 Servo Bus Programmer (USB-C)

$15.99
SKU: 11449

49 Available

Select Store to check availability.

This item is IN STOCK

Details

The FE-URT-2 is FEETECH's USB servo programmer / control board for programming, debugging, and controlling serial bus servos. Connect it to a PC over USB Type-C to assign servo IDs, adjust parameters, and read live feedback, or wire it to a microcontroller through the UART header. One board handles both TTL and RS485 bus servos. It is the updated version of the FE-URT-1, with a Type-C port, an upgraded CH343P USB chip for faster, more stable communication, and the same mounting footprint.

What's Included

  • 1x FEETECH FE-URT-2 board
  • 1x USB-A to USB-C data cable

Specifications

  • Manufacturer: FEETECH
  • Model: FE-URT-2
  • USB Interface: Type-C (CH343P chip)
  • USB Protection: 500mA overcurrent and overvoltage protection
  • Baud Rate: 50 bps - 1 Mbps
  • UART Interface: 2.54mm pitch pin header (for MCU control)
  • TTL Servo Port: 3-pin 5264 (SCS/STS/HLS series)
  • RS485 Servo Port: 4-pin XH, backward compatible with 5264 connectors (SM/SMS series)
  • Power Input: 5.08mm screw terminal block
  • Servo Power Range: 4.8V - 12V on G/V1 (TTL servos), 12V - 24V on G/V2 (RS485 servos)
  • Signal Level: 5V / 3.3V selectable
  • Dimensions: 55.8mm × 36.6mm × 11.5mm
  • Mounting Holes: 3mm, spaced 48.8mm × 28.8mm
  • Weight: 12.5g

Key Features

  • Configure without a power supply: USB can power the servo port for ID and parameter setup, so no external supply is needed for basic configuration.
  • PC or microcontroller control: Use FEETECH's PC software over USB, or connect an MCU (Arduino, ESP32, etc.) through the UART header.
  • Two bus types on one board: Separate TTL and RS485 servo ports.

Compatible With

  • LeRobot SO-100 / SO-101 arms: works as the motor control board. Use one per arm.
  • TTL servos: STS3215 (7.4V and 12V), STS3032, STS3250, SCS0009, HLS3606M, HLS3915M, HLS3950M
  • RS485 servos: SM40BL, SM8524BL, SM120BL, SM160BL

Important

  • When running servos under load, connect an external power supply to the terminal block that matches your servo's rated voltage. 12V STS servos are TTL servos and go on G/V1.
  • RS485 servo power must not exceed 25V.
  • Use a USB data cable. Charge-only USB-C cables will not connect to your computer.
  • Default baud rates: 1,000,000 bps for SCS/STS servos, 115,200 bps for SMS servos.
  • FEETECH does not recommend mixing SCS servos on the same bus with STS or SMS servos.